|
This ornamental water wheel was built using the Base Plate Circle
Jig for the center hubs and the Advanced Circle Jig for the water wheels. The water wheels are approximately 30-inches
in diameter. The two wheels were easy to cut to the same exact dimensions because of the simplicity of making adjustments
with the Dial Indiactor.
The client needed to raise his newel post by 1-inch and he accomplished
this by cutting this 4-inch diameter spacer out of oak. He tried other methods first but could not get the look and finish
he was looking for. Using the Base Plate Circle Jig he cut the spacer in about one minute and achieved the look and
smooth finish he wanted.
| Click to enlarge picture |
|
| CUTTING 9-INCH CIRCLES |
| Click to enlarge picture |
|
| 4 FLOWER POT HOLES |
This beautiful flower post was very simple to build with one 4" X 4" X
84" post and a 24" sq. plywood sheet. Four 9" diameter holes were cut in the plywood sheet with the Base Plate circle
Jig in less than 5 minutes. A quick and inexpensive project that can add a lot of beauty to your yard.
|
